Chip Industry Week In Review


The U.S. Department of Commerce and Texas Instruments (TI) signed a non-binding preliminary memorandum of terms to provide up to $1.6 billion in CHIPS Act funding towards TI’s investment of over $18 billion for three 300mm semiconductor wafer fabs under construction in Texas and Utah. TI also expects to get about $6 billion to $8 billion from the U.S. Department of Treasury’s Investmen... » read more

Why Small Fab And Assembly Houses Are Thriving


High-volume products get more than their fair share of attention in the semiconductor world, but most chips don't fit into that category. While a few huge fabs and offshore assembly and test (OSAT) houses process enormous volumes of chips, small fabs and packaging lines serve for lower volumes, specialized technology, and prototyping. “There are companies that run literally one lot of 25 w... » read more

Defining Chip Threat Models To Identify Security Risks


Experts At The Table: As hardware weaknesses have become a major target for attackers, the race to find new ways to strengthen chip security has begun to heat up. But one-size does not fit all solution. To figure out what measures need to be taken, a proper threat model must be assessed. Semiconductor Engineering sat down with a panel of experts at the Design Automation Conference in San Franci... » read more

Chip Industry Week In Review


The University of Texas at Austin’s Texas Institute for Electronics (TIE) was awarded $840 million to establish a Department of Defense microelectronics manufacturing center. This center will focus on developing advanced semiconductor microsystems to enhance U.S. defense systems. The project is part of DARPA's NGMM Program. The U.S. Dept. of Commerce announced preliminary terms with Global... » read more

Chip Industry Week In Review


JEDEC and the Open Compute Project rolled out a new set of guidelines for standardizing chiplet characterization details, such as thermal properties, physical and mechanical requirements, and behavior specs. Those details have been a sticking point for commercial chiplets, because without them it's not possible to choose the best chiplet for a particular application or workload. The guidelines ... » read more

Chip Industry Week In Review


President Biden will raise the tariff rate on Chinese semiconductors from 25% to 50% by 2025, among other measures to protect U.S. businesses from China’s trade practices. Also, as part of President Biden’s AI Executive Order, the Administration released steps to protect workers from AI risks, including human oversight of systems and transparency about what systems are being used. Intel ... » read more

Chip Industry Week In Review


President Biden announced four new Workforce Hubs to support the CHIPS Act and other initiatives, in Upstate New York, Michigan, Milwaukee, and Philadelphia. The White House also provided economic context and progress updates for the President’s workforce strategy. Samsung began mass production of its ninth-gen industry-first V-NAND chip. Along with one-terabit triple-level cell design, th... » read more

Chip Industry Week In Review


SK hynix and TSMC plan to collaborate on HBM4 development and next-generation packaging technology, with plans to mass produce HBM4 chips in 2026. The agreement is an early indicator for just how competitive, and potentially lucrative, the HBM market is becoming. SK hynix said the collaboration will enable breakthroughs in memory performance with increased density of the memory controller at t... » read more

Chip Industry Week In Review


By Adam Kovac, Karen Heyman, and Liz Allan. Europe's semiconductor footprint is growing in areas that previously had little association with chips. Silicon Box plans to build a panel-level foundry in northern Italy, funded in part by the Italian government. The deal is worth around €3.2 billion ($3.6B). In addition, imec will establish a specialized 300mm chip technology pilot line in M... » read more

Why There Are Still No Commercial 3D-ICs


Building chips in three dimensions is drawing increased attention and investment, but so far there have been no announcements about commercial 3D-IC chips. There are some fundamental problems that must be overcome and new tools that need to be developed. In contrast, the semiconductor industry is becoming fairly comfortable with 2.5D integration, where individual dies are assembled on some k... » read more

← Older posts Newer posts →