How to avoid wafer-based testing during early technology development using a model to determine the optimal Si recess depth target and process window prior to source/drain epitaxy.
A new methodology is demonstrated to assess the impact of fabrication inherent process variability on 14-nm fin field effect transistor (FinFET) device performance. A model of a FinFET device was built using virtual device fabrication and testing. The model was subsequently calibrated on Design of Experiment corner case data that had been collected on a limited number of processed fab wafers. We then performed 400 virtual experiments comprising seven sources of process variation. Using this virtual fabrication technique, we were able to identify a minimum gate-to-source/drain spacer thickness for a high temperature post-EPI rapid thermal anneal (RTA) process that avoided device subthreshold slope penalties. The model allowed us to determine the optimal Si recess depth target and process window prior to source/drain epitaxy. We obtained these results by reviewing device performance as a function of statistical process sensitivity and highlighting key process parameters requiring variation control. These experiments would have been impractical to perform in an actual fab, due to the time, cost, and equipment requirements of running 400 fab-based process variation experiments for each process parameter. This methodology can be used to avoid wafer-based testing during early technology development.
Click here to continue reading.
 |
 |
 |
 |
 |
 |
 |  |
Leave a Reply